» LOG IN to write comment.

wil_hight Slowly but surely the xv500 is progressing!
#xv500 #yamaha #caferacer #croig #caferacersofinstagram #oneupmotogarage
2w

» LOG IN to write comment.

wil_hight Time for the next project
#cb550
#Honda
4w

» LOG IN to write comment.

wil_hight Just Because

#cb350f
2mon
  •   neeko501 Now, Will, were you doing the speed limit? 1mon

» LOG IN to write comment.

wil_hight It's been a while • 2mon

» LOG IN to write comment.

wil_hight This is SO much fun to ride! 3mon
  •   wil_hight @calumjs pushrod tubes 3mon
  •   alittleshortforastormtrooper Braaaaaaap 3mon
  •   calumjs Those pushrod tube seals are not universal. Trick is to dry fit your head and measure the distance between the two mating surfaces where the pushrod tubes seat then measure your tube and use an appropriately sizes seal and load it with threebond. My t140 head was skimmed so much in the past my engine builder had to use billet pushrod tubes so he could machine them down to the required shorter length! 3mon
  •   wil_hight @calumjs I'll give that a try, thanks! 3mon

» LOG IN to write comment.

wil_hight The next project is well underway, but here's the day one picture. #oneupmotogarage #virago #xv500 #yamaha 4mon

» LOG IN to write comment.

wil_hight OH MY GOD 4mon

» LOG IN to write comment.

wil_hight Two new projects! 4mon

» LOG IN to write comment.

wil_hight D'ya like dags? 5mon

» LOG IN to write comment.

wil_hight 1973 Honda CB350f 5mon

» LOG IN to write comment.

wil_hight 1973 Honda CB350f 5mon

» LOG IN to write comment.

wil_hight Still contemplating a front end swap.. 🤔 5mon

» LOG IN to write comment.